Satellite A80 7-3
HW Setup
Boot Priority
Boot Priority Options
This option sets the priority for booting the computer.
You can override the settings and manually select a boot device by pressing
one of the following keys while the computer is booting:
FDD is looked for when the boot disk is contained in external hard disk drive.
To select the boot drive you want, follow the steps below.
1. Boot-up your computer and press F12 to enter the boot menu.
2. The boot select screen will be displayed: HDD, CD/DVD, FDD, and LAN.
3. Use the upper/lower cursor keys to highlight the boot device you want
and press Enter.
Hard Disk Drive Priority Options
If more than one hard disk drive is installed in the computer, this option lets
you set the priority for hard disk drive detection. If the first detected hard
disk drive has a boot command, the system will boot from the hard disk
drive.
Dynamically
Switchable
CPU power consumption and clock speed
automatic switching function is enabled. When
the computer is in use, CPU operation is
automatically switched when necessary (Default).
Always Low CPU power consumption and clock speed
automatic switching function is disabled. The
CPU always runs at low power consumption and
low speed.
U Selects the USB floppy disk drive.
N Selects the Network.
C Selects optical device.
Built-in HDD ->
2nd HDD
The computer will look for the Built-in hard disk
drive first, next the 2nd hard disk drive and then
the hard disk drive (Default).
2nd HDD ->
Built-in HDD
The computer will look for the 2nd hard disk drive
first, next the Built-in hard disk drive, and then the
hard disk drive.
To Next Page
Loading...
