Satellite A80 4-5
Operating Basics
Disconnecting
To disconnect the internal modem cable, follow the steps below.
1. Pinch the lever on the connector in the telephone jack and pull out the
connector.
2. Disconnect the cable from the computer in the same manner.
LAN
The computer is equipped with LAN circuits that support Ethernet LAN (10
megabits per second, 10BASE-T), Fast Ethernet LAN (100 megabits per
second, 100BASE-TX), or Gigabit Ethernet LAN (1000 megabits per second,
1000BASE-T) (depending on the model yor purchased). This section
describes how to connect/disconnect to a LAN.
Connecting LAN cable
If you are using 10BASE-T Ethernet or 100BASE-TX Fast Ethernet, be sure
to connect with CAT5 cable.
If you are using 1000BASE-T Fast Ethernet, be sure to connect with CAT5e
or CAT6 cable.
Do not pull on the cable or move the computer while the cable is connected.
If you use a storage device such as a DVD-ROM drive or HDD connected
to a 16-bit PC card, modem speed might be slow or communication might
be interrupted.
If modem speed is low or communication is interrupted when you are using
modem, please check and set CPU speed to Maximum by TOSHIBA Power
Saver utility.
Do not install or remove an optional memory module while Wake-up on LAN
is enabled.
Wake-up on LAN does not work without the AC adaptor. Leave it
connected, if you are using this feature.
The computer must be configured properly before connecting to a LAN.
Logging onto a LAN using the computer's default settings could cause a
malfunction in LAN operation. Check with your LAN administrator regarding
set-up procedures.
To Next Page
Loading...
