Toshiba Satellite L300 - MDC Module; Removing the MDC Module

4ReplacementProcedures 4.5MDCModule
4-24 SatelliteL300D/L305D/SatelliteProL300D/EQUIUML300D/SATEGOL300D  MaintenanceManual 
4.5 MDCModule
RemovingtheMDCModule
RemovetheMDCModule(ModemDaughterCard)accordingtothefollowingprocedures
andFigures4-10,aftercheckingthatthecomputeristurnedoffinbootmode.
CAUTION:RemovetheMDCmoduleafterturningoffthecomputer.Ifthisisviolated,
thecomputerorMDCmodulecanbedamaged.
1. RemovethetwoM2x3blackflatheadscrewssecuringtheMDCmodule.
2. LefttheMDCmoduleanddisconnectitfromCN6onthesystemboard.
3. DisconnecttheMDCcablefromconnectorJ2ontheMDCcard.
CAUTION:DonottouchtheconnectorsontheMDCmoduleorinthecomputer.
ContaminatedconnectorscancauseMDCmodulefailures.
CN6
M2x2 6blackflatheadscrew.
J1
J2
MDCcard
MDCcable

Figure4-10RemovingtheMDCmodule