Toshiba Satellite L300 - 4.8 Display Assembly

4ReplacementProcedures 4.7DisplayAssembly
4-30 SatelliteL300D/L305D/SatelliteProL300D/EQUIUML300D/SATEGOL300D  MaintenanceManual 
4.8 DisplayAssembly
RemovingtheDisplayAssembly
CAUTION:Usecaretoavoidthattheantennacableisnotcaughtbetweenthedisplay
assemblyandcomputer.
RemovethedisplayassemblyaccordingtothefollowingproceduresandFigures4-14,4-15.
1. TurnthecomputerupsidedownandremovetwoM2.5x6blackflatheadscrews.
2. Restorethenormalcomputerplacementandopenthedisplaypanel.
M2 5x6blackflatheadscrew.

Figure4-14Removingthescrewsfromthebackofthecomputer
3. DisconnecttheLCD/FLcablefromCN5onthesystemboard.
4. DisconnecttheCCDcablefromCN7onthesystemboard.
5. DisconnecttheMICcablefromCN3onthesystemboard.
6. RemovefourM2.5x6blackflatheadscrewssecuringtheLCDmoduletothebottom
cover.
7. Removethewirelessantennacables,CCDcableandMICfromthebottomcover.
8. Removethedisplaymodule.