EasyManua.ls Logo

Toshiba Satellite L300 - 2.8 ODD (Optical Disk Drive)

Toshiba Satellite L300
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2Troubleshooting 2.8ODDDrive
2-18 SatelliteL300D/L305D/SatelliteProL300D/EQUIUML300D/SATEGOL300DMaintenanceManual
2.8 ODD(OpticalDiskDrive)
TocheckiftheinternalODDdriveisdefectiveormalfunctioning,followthetroubleshooting
proceduresbelowasinstructed.
Procedure1ODDCleaningCheck
Procedure2TestProgramCheck
Procedure3ConnectorCheckandReplacementCheck
Procedure1ODDCleaningCheck
1. Turnoffthepowertothecomputer.
2. OpentheODDtraybyinsertingaslenderobjectsuchasastraightenedpaperclipinto
theejecthole.Theobjectmustbelongenoughtoactivatetheejectmechanism.
3. Cleanthelaserpickuplenswithalenscleaner.Applythecleanertoaclothandwipe
thelens.
4. IftheODDdrivestilldoesnotfunctionproperlyaftercleaning,gotoProcedure2.
Procedure2TestProgramCheck
ExecutetheODDdrivetestprogramavailableaspartofthemaintenancetestprogram.Insert
thediagnosticsCDinthecomputer'sCD,turnonthecomputerandrunthetest.Theninserta
testODD(Toshiba-EMIDVD-ROMTESTDISKTSD-1)intotheODDdrive.SeeChapter3
forinformationonhowtoperformthetest.
Ifanyerrorisdetectedbythetest,gotoProcedure3.
Procedure3ConnectorCheckandReplacementCheck
TheODDdriveisconnectedtothesystemboardbytheconnector.Theconnectormaybe
disconnectedfromthesystemboardorfaulty.Disassemblethecomputerfollowingthesteps
describedinChapter4andperformthefollowingchecks:
Check1 MakesurethefollowingconnectorhasbeenfirmlyconnectedtotheODD
driveandthesystemboard.
Iftheconnectorislooseoroff,reconnectitfirmlyandreturntoProcedure2.
Ifthereisstillanerror,performCheck2.
Check2 Theconnectormaybefaulty.Replacetheconnectorwithanewone
followingthestepsinChapter4.IftheODDdriveisstillnotfunctioning
properly,performCheck3.
ODD
Drive
Systemboard
CPU
Attachmentcase
Connector

Table of Contents

Related product manuals