Toshiba Satellite L300 - Procedure 5 Connector Check and Replacement Check

2Troubleshooting 2.52.5-inchHDD
2-14 SatelliteL300D/L305D/SatelliteProL300D/EQUIUML300D/SATEGOL300DMaintenanceManual
Procedure5ConnectorCheckandReplacementCheck
TheHDDorsystemboardmaybefaulty.Disassemblethecomputerfollowingthesteps
describedinChapter4andperformthefollowingchecks:

Check1  Makesurethefollowingconnectorshavebeenfirmlyconnectedtothe
HDD,systemboardandCPU.
HDD
Systemboard
CPU


Ifanyconnectorislooseoroff,reconnectitfirmlyandreturntoProcedure1.
Ifthereisstillanerror,performCheck2.

Check2 TheHDDmaybedamaged.Replaceitwithanewonefollowingthe
disassemblinginstructionsinChapter4.Iftheproblempersists,perform
Check3.

Check3 TheSystemboardmaybedamaged.Replaceitwithanewonefollowing
thedisassemblinginstructionsinChapter4.Iftheproblempersists,
performCheck4.

Check4 TheCPUmaybedamaged.Replaceitwithanewonefollowingthe
disassemblinginstructionsinChapter4.