4 Replacement Procedures 4.5 ODD
Installing the ODD
Install the ODD according to the following procedures.
1. Insert the ODD into the ODD bay.
2. Slide the ODD bay inward until it meets the end.
3. Secure the ODD with one M2.5x5 screw.
Disassembling the ODD
NOTE: Do not disassemble the ODD when it is working normally. Disassemble or replace
the ODD only if it fails.
Disassemble the ODD according to the following procedures and Figure 4.9.
1. Remove two M2x3 screws securing the ODD bracket to the ODD.
2. Remove the ODD bracket from the ODD.
M2×3*2
Figure 4.9 Removing the ODD bracket from the ODD
Assembling the ODD Drive
Assemble the ODD drive according to the following procedures.
1. Seat the ODD bracket in the correct position on the ODD.
2. Secure the ODD bracket to the ODD with two M2×3 screws.
[CONFIDENTIAL] Satellite L670/Pro L670 Maintenance Manual
To Next Page
Loading...
