Replacement Procedures
4-26 Satellite P100 Maintenance Manual (960-Q02)
4.9 Optical disk drive
NOTE: Do not apply excessive force to the top of an optical disk drive.
Do not touch the shaded portion of the figure below, when the drive is removed
or installed.
Removing an optical disk drive
The following describes the procedure for removing an optical disk drive (See Figure 4-
11and 4-12).
1. Remove Keyboard and next remove the following screws securing an optical disk
drive.
• M2.0×6.0B FLAT BIND screw x1
2. Disconnect an optical disk drive toward the arrow direction from the connector CN26
on the system board.
Figure 4-11 Removing an optical disk drive
Optical disk drive
M2.5 x 6.0B FLAT BIND
Push Out
To Next Page
Loading...
