Replacement Procedures
Satellite P100 Maintenance Manual (960-Q02) 4-33
4.11 Bluetooth
The following describes for installing the display assembly (See Figure 4-18).
Removing the Bluetooth
1. Pull out the Bluetooth cable connect from Bluetooth board
2. Loose the below screw and pull out the MB->BT cable.
z M2.3x3.0 x2
Figure 4-18 Removing the Bluetooth
Installing the Bluetooth
1. Fix the below screw
z M2.3x3.0 x2
2. Connect Bluetooth cable with MB and press Bluetooth antenna tight with Bluetooth
connect
NOTE: Be sure to apply the locktight to the screws instructed in the figure above.
M2.0*3.0
Bluetooth
Antenna
To Next Page
Loading...
