User’s Manual 8-9
Optional Devices
7. Push the module down so it lies flat. Latches on either side will click into place
to secure the module.
Installing the memory module
8. Seat the cover and secure it with the screws.
9. Replace the battery pack as described in Chapter 6, Power and Power- Up
Modes.
10. Turn the power on and make sure the added memory is recognized: Go to
Control Panel System and Security System.
Points to note about memory module error
If you install a memory module that is not compatible with the computer, the Power
indicator will ash (on for 0.5 seconds, off for 0.5 seconds) in the following ways:
nIf there is only an error in Slot A: repeatedly flashes orange twice, then blue.
nIf there is only an error in Slot B: repeatedly flashes orange, then blue twice.
nIf there is an error in Slot A and in Slot B: repeatedly flashes orange twice,
then blue twice.
In all instances you should shut down the computer and remove the incompatible
module(s)
To Next Page
Loading...
