Toshiba T3100e - Running Test Sequence; Running Test Program Description; Running Test Operations

File No. 960-010
3.21 RUNNING TEST
3.21.1 Program description
This program automatically runs the following tests in sequence.
1. System test (subtest number 01)
2. Memory test (subtest number 01, 02, 03, 04, 06)
3. Display test (subtest number 01 to 08)
4. FDD test (subtest number 02)
5. Printer test (subtest number 03)
6. Async test (subtest number 01)
7. HDD test (subtest number 01, 05)
8. Real timer (subtest number 02)
When running an FDD test, this system automatically decides
whether there are one or two FDDs.
3.21.2 Operations
CAUTION: Do not forget to load a work disk. If a work disk
is not loaded, an error will be generated during FDD testing.
1. Remove the diagnostics disk and insert the work disk into
the floppy disk drive.
2. After pressing 6 and Enter in the DIAGNOSTIC MENU, the
following message will appear.
Printer wrap around test (YIN) ?
3. Select whether to execute the printer wraparound test (Yes)
or not (No). Type Y or N and press Enter. (If Y is selected,
a wraparound connector must be connected to the printer
connector on the back of the unit.) The following message
will appear.
Async#l wrap around test (YIN) ?
Async#2 wrap around test (YIN) ?
4. Select whether to execute the test (Yes) or not (No). Type Y
or N and press Enter. (If Y is selected, an RS-232-C
wraparound connector must be connected to the SER. A or SER.
B connector on the back or right side of the unit.)
5. This program is repeated continuously. To stop the program,
press Ctrl + Break.
3-39