T3400, T3400CT
Installation
To install the HDD, follow the steps below and refer to Figures 4-11 through 4-13.
1. Seat the HDD in its bracket (Figure 4-13).
2. Secure the HDD to the bracket with four M3x4 flat-head screws (Figure 4-13).
3. Fit the HDD flexible cable under three latches on the bracket (Figure 4-12).
4. Connect the flexible cable to the HDD (Figure 4-12).
5. Secure the flexible cable with one M2.5x4 brass screw (Figure 4-12).
6. Seat the HDD into the bottom cover (Figure 4-11).
7. Connect the flexible cable to PJ5 on the system board (Figure 4-11).
8. Secure the HDD with one M2.5x6 brass screw (Figure 4-11).
9. Replace the top cover, optional PCMCIA card, optional memory card, and battery
pack as described in sections 4.5 through 4.2.
To Next Page
Loading...
