T3400, T3400CT
4.2 The Battery Pack
Removal
To remove the battery pack, follow the steps below and refer to Figures 4-1 and 4-2.
1. Turn off the power and disconnect the AC adapter, power cord, and all external
cables.
2. Close the display if open.
3. Turn the computer upside down.
4. Slide the battery lock to free the battery release latch, then slide the release latch
to pop the battery out slightly to the left (Figure 4-1).
Figure 4-1 Unlocking the Battery Pack
5. A slight gap will open between the right end of the battery pack and the computer.
With your left hand, slip your fingers into the gap and pull the battery pack to the
left until it stops (about 1 centimeter or 1/2 inch).
6. Grasp the left end of the battery pack and lift up to remove (Figure 4-2).
Figure 4-2 Lifting Out the Battery Pack
To Next Page
Loading...
