T3400, T3400CT
Installation
To install the battery pack, follow the steps below and refer to Figures 4-1 and 4-2.
1. Place the right end of the battery pack about halfway between the display latch and
the battery pack terminals.
2. Slide the battery pack to the right until it snaps on. There will still be a gap be-
tween the right end of the battery pack and terminals (Figure 4-2).
3. Gently press down on the center of the battery pack and at the same time push it to
the right. Slight resistance will be felt when the battery is nearly seated. Press in
carefully until it clicks into place, then lock the battery lock (Figure 4-1).
To Next Page
Loading...
