Toshiba T3400CT - AccuPoint Control Button Procedures; AccuPoint Control Button Removal Steps

T3400, T3400CT
4-19
4.8 AccuPoint Control Button
Removal
To remove the AccuPoint control button, follow the steps below and refer to Figure 4-15.
1. Turn off the power and disconnect the AC adapter, power cord, and all external
cables.
2. Remove the battery pack, optional memory card, optional PCMCIA card, and top
cover as described in sections 4.2 through 4.5.
3. Disconnect the control button cable from PJ801 on the power supply/system
joint board (Figure 4-15).
4. Slide the control button and cable free of latches on the bottom cover and lift out
to remove (Figure 4-15).
Figure 4-15 Removing the AccuPoint Control Button