T3400, T3400CT
(c) Remove the Diagnostics Disk from the FDD, insert the source disk, and
press any key. The following message indicates the program has started.
[ FDD TYPE ] : TRACK = XXX
[ FDD TYPE ] : HEAD = X
[ FDD TYPE ] : SECTOR = XX
Copy start
[[ track,head = XXX X ]]
(d) Remove the source disk from the FDD, insert a formatted work disk, and
press any key. The [[ track, head = XXX X ]] message will appear and
start copying to the target disk. When data cannot all be copied in one
operation, the message from step (b) is displayed again. After the floppy
disk has been copied, the following message will appear:
Copy complete
Another copy (1:Yes/2:No) ?
(e) To copy another disk, type 1 and the message from step (a) will be displayed
again. Enter 2 to return to the DIAGNOSTIC MENU.
4. DUMP program
(a) Select dump to display the following message:
DIAGNOSTICS-HARD DISK & FLOPPY DISK DUMP : VX.XX
Drive type select (1:FDD, 2:HDD) ?
(b) Select a format type number. If 2 is selected, the display will go to step (e).
Select FDD number (1:A, 2:B) ?
(c) Select a drive number and the following message will be displayed:
Format type select (0:2DD, 1:2D, 2:2HD) ?
(d) Select a media type number and the following message will appear:
Insert source disk into drive A:
Press any key when ready.
(e) Insert a source disk and press any key and the following message will appear:
—— Max. address ——
[Track ] = 0079
[ Head ] = 01
[Sector] = 09
Track number ??
(f) Set a track number to dump. The system will access the disk and dump a
list.
To Next Page
Loading...
