-2-
4. How to install
1. Peel off the tape fi xing the fi lter rail. 4. Install (2) Filter frame.
And check if the claw of the fi lter rail is not taken off.
Tape
Tape
Tape
(2) Filter frame
(6) Screws Ø13/64″ × 0.3″ (M5 × 8) (4pcs)
(2) Filter frame
(5) Screws Ø5/32″ × 0.3″ (M4 × 8) (4pcs)
The fi lter frame gets one having black mold parts (fi lter rail)
in the lower direction at the time of the installation of indoor unit.
2. Install (9) (10) Seal material. 5. Install (8) Seal material.
Fit the seal material to the corner and paste it.
(10) Seal material
(2) Filter frame
(10) Seal material
(9) Seal material
(9) Seal material
(8) Seal material
(8) Seal material
Stick the seal
material on the
basis of this position.
3. Install (1) Frame fi x plate. 6. Install (3) Filter and (4) Cover.
(1) Frame fi x plate
(7) Screws Ø13/64″ × 0.6″ (M5 × 16) (18pcs)
Tighten this screw temporarily.
After attaching the fi lter frame, tighten it
completely.
Handle
(3) Filter (2pcs)
(5) Screws
Ø5/32″ × 0.3″ (M4 × 8)
(2pcs)
(4) Covers (2pcs)
(5) Screws
Ø5/32″ × 0.3″
(M4 × 8) (2pcs)
For the fi lter direction, the insertion direction is the handle side as
the above picture.
Please confi rm that two pieces of fi lters are connected.
Please attach the cover with both side.
NOTE
When you use too long screws at attach a suction duct (local procured), you can not remove the fi lters by attack the screws.
Be sure to check if the fi lter can be attached and removed after the attachment.
01_1116950301-1 EN.indd 201_1116950301-1 EN.indd 2 29/9/2564 BE 08:5629/9/2564 BE 08:56
To Next Page
Loading...
Need help?
General