Central remote controller Owner’s Manual
13
-EN
When “--” is displayed on the “Control” screen of All or Zone
When a blank is displayed on the “Control” screen of Unit
When the following is displayed on the “Control” screen of Unit
Displayed when the air conditioner settings do not match.
• When you have configured the settings on the “Control” screen of All or Zone but
there is an air conditioner whose settings become invalid because there is no
corresponding function.
• When you have changed any individual setting using the local remote control after
changing the settings on the “Control” screen of All or Zone.
• If you press [ ] (Confirm) with “--” displayed, the air conditioner is not set.
A blank is displayed if there is a function whose settings cannot be changed.
The screen shown at the left is an example of the model having a fixed louver.
Blank spaces cannot be selected using [<] or [>].
The Air to air heat exchanger or general-purpose device control interface is
registered.
The only possible operation is the start/stop operation.
When the Air to air heat exchanger is registered, you can set “Ventilation” in the
“Menu” screen.
To Next Page
Loading...
