Toshiba TDP-P9 - Page 18

TDP-P9 13
Step Figure Description
3
Turn the projector over
and remove the top cover
(Be careful of the FPCB
between keypad and main
board). Then disconnect
the flex wire (FFC).
Remove the screws on
the back cover as shown.
Note: Screw-mylar can
cover on the screws to
decorate the back cover.
There is a photo showing
you what the connector
should be.
Left Fan
5 pin for Ballast
Color wheel
CW sensor
Front IR O/E Fan
DC
p
ower in
Ri
g
ht Fan