Toshiba TDP-P9 - Disassembly Lamp Module

TDP-P9 17
3.3 Disassembly Lamp Module
Step Figure Description
1
z Turn off the projector.
z Unplug the power cord.
z Remove the lamp cover.
2
z Loosen the two screws of lamp
module
z Pull the lamp module out by lamp
handle.
z Insert the new lamp module into
the projector and tighten the
screws.
z Replace the lamp cover and
tighten the screws.
Note: Turn on the projector. If the lamp
does not turn on after the warm-up
period, please reinstall the lamp.