User’s Manual 8-27
TECRA A10/S10/M10/SatellitePro S300
Bluetooth
For further information on Bluetooth wireless communication, please refer
to Chapter 4, Operating Basics.
Recovery Discs
Problem Procedure
Cannot access
Bluetooth device
Check to ensure the computer’s Wireless
Communication Switch is set to on.
Check to ensure the Bluetooth Manager
application is running on the computer and that
power to the external Bluetooth device is turned
on.
Check to ensure that no optional Bluetooth
Adaptor is installed in the computer - the built-in
Bluetooth hardware cannot operate
simultaneously with another Bluetooth controller.
If you are still unable to resolve the problem,
contact your reseller, dealer or service provider.
Problem Procedure
The following
message appears
when executing
Recovery Disc
Creator.
“The Recovery
Disc Creator can
not be launched
because there is
no recovery
partition.”
You will see this message if you have previously
chosen to remove the partition and are trying to
create “Recovery Media”.
When there is no recovery partition, the Recovery
Disc Creator cannot make Recovery Media.
However, if you have already created a
“Recovery Media”, you can use it to restore the
recovery partition.
Simply follow the instructions in Restoring the
pre-installed software from your created
Recovery Discs section in Chapter1, Getting
Started.
You will be directed to select “Restore Original
Factory Image” from the drop-down menu.
If you have not created “Recovery Media”, please
contact TOSHIBA support for assistance.
To Next Page
Loading...
Need help?
General
