Name: Toshiba TECRA A10
Brand: Toshiba
Rating: 5 (1 reviews)

To Next Page

To Previous Page

User’s Manual 3-33

TECRA A10/S10/M10/SatellitePro S300

Disconnecting the i.LINK (IEEE1394) cable

To disconnect the i.LINK (IEEE1394) cable, follow the steps as detailed

below:

1. Open the Safely Remove Hardware icon on the Windows Taskbar.

2. Point to i.LINK (IEEE1394) device and click.

3. Disconnect the cable from the computer then from the i.LINK device.

Serial port

The serial connector can be used to connect to RS-232C compatible

devices.

RS-232C compatible devices include the following:

■ Modem

■ Mouse

■ Printer

Some models are equipped with a serial port.

To connect a serial port, follow the steps as detailed below:

1. Turn the computer’s power off.

2. Connect the serial connector to the serial port and tighten the screws on

the left and right hand side.

Figure 3-17 Connecting the serial connector to the serial port

Refer also to the documentation that came with your i.LINK device.

Serial connector

Serial port

Other manuals for Toshiba TECRA A10

Questions and Answers:

Need help?

Do you have a question about the Toshiba TECRA A10 and is the answer not in the manual?

General