3-14 User’s Manual
TECRA A10/S10/M10/SatellitePro S300
TOSHIBA USB Sleep
and Charge Utility
This utility is able to either enable or disable the
USB Sleep and Charge function.
Shows the positions of USB ports that support
the USB Sleep and Charge function and displays
the battery’s remaining capacity.
To start this utility, click Start -> All Programs ->
TOSHIBA -> Utilities -> USB Sleep and
Charge.
Trusted Platform
Module (TPM)
The TPM (Trusted Platform Module) is a security
encryption device for the hard disk drive.
BIOS setup and Infineon TPMSoftware
Professional Package must be configured in
order to use TPM.
For further information on how to set up and use
this utility, please refer to the Infineon TPM
Installation Guide.
To enable TPM through the BIOS setup:
1. Turn on the computer while pressing the ESC key.
2. Press the F1 key when directed.
3. Press the PGDN key.
4. Press the down arrow key until TPM is highlighted, then press the
space bar to change the TPM status to Enabled.
5. Press the Y key to save the changes.
6. Press END and then press the Y key to accept the changes.
The computer will restart.
In order to change the TPM setting when the Hide TPM setting is currently
set to Yes, switch the Hide TPM setting from Yes to No.
To Next Page
Loading...
