User’s Manual 6-9
Power and Power-Up Modes
6. Slide and hold the battery release latch (2) and then remove the battery
pack from the computer (3).
Figure 6-1 Releasing the battery pack
Installing the battery pack
To install a battery pack, follow the steps as detailed below:
1. Insert the battery pack as far as it will go into the computer (1).
2. Ensure that the battery pack is securely in place and the battery lock (2)
is in its ( ) position.
Figure 6-2 Securing the battery pack
3. Turn your computer over.
Battery
release latch
Battery pack
Battery lock
Do not touch the battery release latch while holding the computer or the
battery pack might fall out due to the unintentional release of the battery
release latch and cause injuries.
Battery pack
Battery lock
Downloaded from LpManual.com Manuals
To Next Page
Loading...
