EasyManuals Logo

Toshiba TLP-X3000 User Manual

Toshiba TLP-X3000
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
25
Operations
24
Turning the power on and off
Operations
Connecting the power cord
1
Insert the power cord connector into
the AC IN socket of the projector.
2
Insert the power cord plug into a
wall or other power outlet.
The ON/STANDBY indicator will
change to orange, indicating standby
mode.
Removing the lens cover
Be sure to remove the lens cover when the power is
turned on. If it is left on, it could become deformed due
to heat.
Turning the power on
Press the ON/STANDBY
button.
When the beep sound is [On], the
projector beeps, the power turns on,
and the ON/STANDBY indicator lights
in green. After a moment, the start-up
screen appears.
CAUTION
Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyes or sight.
Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.
Do not place your hands, face, or other objects near the air exhaust. Doing so could cause
burns, deform/break the object.
Power cord connector
(Supplied)
Start-up screen
Control panel
Remote
Control
Notes
When COMPUTER 2 IN terminal (also used for MONITOR OUT terminal) is used as
MONITOR OUT terminal, the signal which is input to COMPUTER 1 IN terminal is output.
Signals are output from MONITOR OUT terminal even in standby mode.
However, from AUDIO OUT terminal, no audio signal is output.
•A computer monitor cannot accept Y/P
B/PR signals correctly.
The AUDIO IN terminal doubles for devices connected to COMPUTER 1 terminal and
COMPUTER 2 terminal.
When an AUDIO OUT terminal is connected, sound is not output from the projector
speaker.
Output volume of AUDIO OUT terminal can be adjusted by the VOL button.
•Moving pictures played back on computers using DVD software may appear unnatural if it
is projected with this projector, but it is not a malfunction.
Label locations
Connection (Continued)
Caution – use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
TLP-X2000 TLP-XC2000 TLP-XC2000
Remote control Document camera

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toshiba TLP-X3000 and is the answer not in the manual?

Toshiba TLP-X3000 Specifications

General IconGeneral
Display diagonal0.7 \
Number of colors16.78 million colors
Projection distance1.45 - 11.29 m
Vertical scan range50 - 85 Hz
Horizontal scan range15 - 106 kHz
Contrast ratio (typical)400:1
Screen size compatibility0.84 - 7.62 \
Projector native resolutionXGA (1024x768)
I/O ports2 x RCA- in 1 x Stereo Mini jack-in 1 x Stereo Mini Jack-out\\r
Resolution786.432 pixels
Aspect ratio4:3
RS-232 ports1
Dimensions (WxDxH)188 x 247 x 82 mm
Power requirementsAC100- 240V, 50 / 60Hz
Lamp power210 W
Light source typeLamp
Service life of light source3000 h
Serial interface typeRS-232
VGA (D-Sub) ports quantity3
Weight and Dimensions IconWeight and Dimensions
Weight2800 g

Related product manuals