Toshiba TOSVERT VFS15-4075PL-W User Manual

E6581611
F-14
6
:
Communication
option
Frequencies are set by commands from a communication option.
 Refer to each Instruction Manual of option.
:
Terminal VIC
A frequency command is set by means of external analog signals.
(VIC terminal: 0 (4) - 20mAdc)
 Refer to section 3.2.2 and 7.3
:
Pulse train input
A frequency command is set by means of external pulse train signals.
(S2 terminal: 10pps - 2kpps)
 Refer to section 6.10.5
14: sro
Frequencies are set by sro parameter.
 Refer to section 5.7.
● The control input terminal in which the following functions are set is always valid regardless of the setting of
 and .
 Reset (valid only for tripping)
 Standby
 External input tripping stop command
 Coast stop command terminal
● To make changes in the command mode selection  and the frequency setting mode selection 1
, first stop the inverter temporarily.
(Can be changed while in operation when  is set to .)
● Priority commands from communications or terminal blocks are given priority over .
 Preset-speed operation
: Set to  (Terminal block operation)
: Valid in all setting values.
 Input terminal settings
Assign the following functions to the input terminal to allow switching of the frequency command by turning
the terminal ON/OFF.
Input terminal function ON OFF
48 Forced local from communication
Enabled during communication
Local (Setting of , )
Communication
106
Frequency setting mode terminal
block
Terminal block (VIA) enabled setting of 
Each of the following numbers (49, 107) are reverse signals.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net

Toshiba TOSVERT VFS15-4075PL-W Specifications

General

Brand	Toshiba
Model	TOSVERT VFS15-4075PL-W
Category	Inverter
Language	English