Toshiba TOSVERT VFS15-4075PL-W User Manual

E6581611
G-5
7
 List of logic input terminal function settings
Parameter
programmed value
Function
Parameter
programmed value
Function
Positive
logic
Negative
logic
Positive
logic
Negative
logic
No function
  Integrating wattmeter (kWh) display
clear
Forward run command   Trace back trigger signal
Reverse run command
  Light-load high-speed operation
prohibitive signal
Standby   Holding of RY-RC terminal output
Reset command   Holding of OUT-NO terminal output
    Preset-speed command 1   Frequency UP *2
    Preset-speed command 2   Frequency DOWN *2
    Preset-speed command 3   Clear frequency UP/DOWN *2
    Preset-speed command 4   Coast stop command
    Jog run mode   Forward/reverse selection
    Emergency stop by external signal    Run/Stop command
    DC braking command
   Frequency reference command forced
switching
    2nd acceleration/deceleration     Frequency setting mode terminal block
    3rd acceleration/deceleration     Command mode terminal block
    2nd V/F control mode switching    Parameter editing permission
    2nd stall prevention level     Fast stop command 1
    PID control prohibition    Fast stop command 2
    External thermal error input    Traverse permission signal
    Forced local from communication     Low voltage operation
    Operation hold (hold of 3-wire operation)    Forward deceleration
    PID integral/differential clear   Forward stop
    PID characteristics switching    Reverse deceleration
    Forced run operation    Reverse stop
    Fire speed operation  to  Factory specific coefficient *1
    Acceleration/deceleration suspend signal   No.2 motor switching
    Power failure synchronized signal    Parameter editing prohibition
    Factory specific coefficient *1    Parameter reading prohibition
    Factory specific coefficient *1 
*1: Factory specific coefficients are manufacturer setting menus. Do not change the value of these parameters.
*2: Active when  (frequency setting mode selection) =  (UP/DOWN from external logic input) is set.
The frequency setup range is from  to  (maximum frequency). The acceleration/deceleration time
relative to the set frequency is / while the acceleration/deceleration speed is not switched.
● Refer to section 11.6 for details about the input terminal function.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net

Toshiba TOSVERT VFS15-4075PL-W Specifications

General

Brand	Toshiba
Model	TOSVERT VFS15-4075PL-W
Category	Inverter
Language	English