E6581611
G-7
7
Assign one type of function to an output terminal
Terminal
symbol
Title Function Adjustment range Default setting
RY-RC
Output terminal selection 1A
0 - 255
4 (Low-speed detection
signal)
OUT
Output terminal selection 2A
6 (Output frequency
attainment signal)
FL
(A, B, C)
Output terminal selection 3 10 (Fault signal)
Note 2) When assigning 1 type of function to the RY-RC terminal, set only .
Leave parameter as the default setting ( = ).
Note 3) When assigning 1 type of function to the OUT terminal, set only .
Leave parameter as the default setting ( = ).
Assign two types of functions to the output terminal (RY-RC, OUT)
Terminal
symbol
Title Function Adjustment range Default setting
RY-RC
Output terminal
selection 1A
0 - 255
4 (Low-speed
detection signal)
Output terminal
selection 1B
255 (Always ON)
OUT
Output terminal
selection 2A
6 (Output frequency
attainment signal)
Output terminal
selection 2B
255 (Always ON)
RY-RC,
OUT
Output terminal logic
selection
0: and
and
0
1: or
and
2: and
or
3: or
or
Note 4) and are active only when = : Logic output (default).
Function is inactive when = : Pulse train output is set.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
Need help?
General