PROGRAMMING
THE
REMOTE CONTROL (Continued)
l This Remote Control is capable of learning operating codes from most infrared remote control transmitters. You can
control the functions of your TV and a variety of video/audio equipment with the supplied Remote Control only.
l The 31 buttons
a
can be used as Learning buttons.
-
LEARN-USE
switch
TO LEARN OPERATING CODE OF ANOTHER REMOTE
CONTROL
1
Set the
TV/CABLE/VCR/AUX
switch to “AUX”.
2
Set the LEARN-USE switch to “LEARN”
LEARN(uUSE
3
Place the supplied Remote Control and the remote control transmitter
to be learned, head to head approximately 1 to 3 inches (3 to
8cm)
apart.
Supplied Remote Remote to be
Control
learned
4
Hold down the button to learn on the supplied Remote Control for
about 1 second
until the LEARN indicator lights up.
When you press a button other than a Learning button,
the
indicator
will blink.
5
Hold down the function button to be learned on the remote control
transmitter for about 3 seconds until the LEARN indicator goes off.
Note:
If the LEARN indicator blinks, the supplied Remote Control
cannot learn the operating code or an error has occurred.
Try steps 4 and 5 again.
6~
epeat steps 4 and 5 for other function keys.
7
Set the LEARN-USE switch to “USE”.
LEARNFIUSE
8
To check your programming, operate the appropriate equipment with
the supplied Remote Control. If the equipment does not operate as
expected, repeat steps 3 to 7.
If needed, try changing the distance between the two remote controls,
To Next Page
Loading...
