Toshiba VCR remote - TO CANCEL THE LEARNED OPERATING CODES

9 Attach th
e supplied template to the Remote Control to enter the
function names of the AUX buttons you have programmed.
Use a ballpoint pen etc. to write the function names.
PC AUD. SET UP OPTION
0000
“rs’pra~
c(J h(y~~D3pi
;
i
i
I
IW
LEARN m USE
TO CANCEL THE LEARNED OPERATING CODES
1 Set the TV/CABLE/VCR/AUX switch to AUX.
2 Set the LEARN-USE switch to LEARN.
LEARN 1-u USE
3 Hold down the button of the function to cancel on the Remote Control
for about 1 second until the LEARN indicator lights up.
4 Hold down RECALL and RESET at the same time for about 6 seconds
until the LEARN indicator goes off after blinking.
Note:
You cannot cancel the programming if you release the button
while the indicator is blinking.
5 Set the LEARN-USE switch to USE.
LEARNUIUSE