Reference Information
Toshiba 2-3
13
PREPARATION
Auto Set Up
The VCR’s clock and tuner channels are set automatically when the VCR is plugged into the AC outlet.
PREPARATION
Auto Set up
1
Plug the VCR into the AC outlet
2
“Auto” blink while the VCR automatically sets the clock using
the data broadcast by the local TV stations.
While “Auto” is blinking, channel memory is also set
automatically.
3
When Auto set up has been completed, the VCR is on
standby mode.
Notes
• It may takes several minutes during the Auto set-up
• Press
CANCEL
on the remote control to cancel the auto set-up.
CANCE
SLOW
PAUSE/STILL
STOP
FF
REC
TIMER
VC-413
TV
VCR
POWER
I.SELECT
SP/SLP
DISPLAY
TV VOL
COUNTER
PROG.
CANCEL
1
2
3
4
5
0
100
6
REW
PLAY
REMAIN/
RESET
COUNT
9
87
EJECT
ENTER
12
This set-up will enable you to:
– watch an unscrambled or scrambled channel
while recording it.
– record any channels through the cable box.
You will need to:
• set TV channel 3 or 4 to receive video signals.
(See page 11.)
• set VCR channel to the output channel of the
cable box, and select a desired cable channel
on the cable box.
• while the VCR is turned off or the “VCR”
indicator is not lit in the VCR display, set TV
channel to the output channel of the cable box.
This set-up will enable you to:
– watch an unscrambled or scrambled channel
while recording it.
– record an unscrambled channel while watching
another unscrambled channel (only when you
connect a cable-compatible TV).
• A/B switch “A”: record and watch an
unscrambled channel which
comes bypassing the cable
box.
• A/B switch “B”: record and watch a scrambled
or unscrambled channel coming
through the cable box.
Incoming cable
Cable box
OUT
IN
A/B switch
CH
OUT
(
TO TV)
IN
(FROM ANT.)
OUT IN
VIDEO
AUDIO
34
RF
Cable box
A
B
A
B
A
B
CH
OUT
(
TO TV)
IN
(
FROM ANT.)
OUT IN
VIDEO
AUDIO
34
RF
This set-up will enable you to:
– record an unscrambled channel.
– watch an unscrambled channel while recording it.
– record an unscrambled channel while watching
another (scrambled or unscrambled).
You will need to:
• set TV channel to the output channel of the cable
box.
• turn on the cable box and select cable channel 3
or 4 according to the output channel of the VCR.
• to record a channel while watching another,
press
TV/VCR
on the remote control to turn off
the “VCR” indicator in the VCR display and select
a desired cable channel on the cable box.
Connections (continued)
CH
OUT
(
TO TV)
IN
(
FROM ANT.)
OUT IN
VIDEO
AUDIO
34
RF
CH
OUT
(TO TV)
IN
(
FROM ANT.)
OUT IN
VIDEO
AUDIO
34
RF
This set-up will enable you to:
– watch or record a channel through the cable
box via the LINE IN (AUDIO/VIDEO) jacks.
You will need to:
• press
I.SELECT
so that the VCR display
shows “L”.
Cable box
Incoming cable
Cable box
OUT
IN
To Next Page
Loading...
