Drive Specifications 15
Reliability
Power Supply, I/O Terminals (bare drive)
Environment
Dimensions
a. 1X rotational speed is fixed for CD-audio (Red-book) format.
b. Measured by performing multiple accesses which means reads of data blocks over the whole
area of the media from 00 min 02 sec 00 block to 60 min 01 sec 74 block more than 3000
times. Includes positioning, setting, latency time and ECC implementation time (if required).
c. Measured by performing multiple accesses which means seeks of data blocks over whole area
of the media from 00 min 02 sec 00 block to 60 min 01 sec 74 block more than 3000 times.
Includes positioning, setting time which is same definition as HDD.
d. Measured by performing multiple maximum access which means reads of data blocks over
the whole area of the media from 00 min 02 sec 00 block to 60 min 01 sec 74 block more than
100 times. Includes positioning, setting and latency time. Typical value is for the average
drive.
1. Hard read error rate (Byte error rate)
Allowing 5 retries
Mode 1: Less than 10
-15
Mode 2: Less than 10
-12
2. Mean time between failures 100,000 power-on hours
1. Voltage +5V ± 5% operating, ± 8% start
+12V ± 5% operating, ± 8% start
2.
Current (typical)
Idle (laser off, motor off)
Continuous read (data/audio)
Pause (laser on, motor on)
Average (20% random access)
Maximum (100% random access)
Peak in executing access (10 to 300ms)
+5V +12V
0.33 A 0.08 A
0.43 A (1X) 0.14 A (1X)
0.48 A (13.8-32X) 0.40 A (13.8-32X)
0.54 A (13.8-32X) 0.46 A (13.8-32X)
0.55 A (13.8-32X) 0.61 A (13.8-32X)
1.13 A (13.8-32X) 1.19 A (13.8-32X)
3. Signal interface connector Complies with SCSI-2 specification
4. Headphone output level 0.9 Vrms typical (load = 100 ohm)
Temperature, operating
Temperature, storage
Humidity, operating
(wet bulb: 27°C), non-operating
5 to 50°C
-10 to 60°C
8 to 80%
5 to 95%
Dimensions (without bezel)
Weight
146 X 41.5 X 193mm (W/H/D)
0.98 kg (net)