14
Table of Contents
5.6 ADVANCED SETTINGS FOR THE LOCK
On the Advanced settings page you can congure LAN
and Internet access restrictions and security related
settings.
Log in as admin8.
Choose “Settings” > “Advanced settings”9.
Conrm changes > Save 10.
5.7 INTERNET CONNECTION PRIORITIES
Several alternative internet connections can be used by the
Lock. One of the available connections can be selected as
a main connection and the other connections can be set as
backup connections. In the event that the main connection
is interrupted, the connection is automatically shifted to
preselected backup connections according to the priority
setting (eg. WAN port --> USB Modem).
5.8 PoE
The “PoE out” port supports PoE output, with auto
detection feature. This means you can connect laptops
and other non-PoE devices without damaging them. The
PoE on “PoE out” outputs approximately 2V below input
voltage and supports up to 0.58A (So e.g. 24V PSU will
provide 22V/0.58A output to the “PoE out” port).
The device accepts powering from the power jack or from
the “PoE in” port (passive PoE)
DC power jack (5.5mm outside and 2mm inside diameter, female •
center pin positive) accepts 8-27V DC +/-10%
The “PoE in” port accepts passive Power over Ethernet 8-27V DC
•
+/-10%
Under maximum load, the power consumption of this
device is 7W.
To Next Page
Loading...