| English
17
To remove the nylon cutting head, put a metal locking tool into the tool and then
unscrew the nylon cutting head.
Hedge trimmer (See Figure F)
Install the bar of the main unit. Be sure that the locking pin is inserted in the hole of
the bar
Fix the bar by turning the nut anticlockwise.
Press the release / safety plate to loosen and turn the unit to the desired position
according to the type of work to be performed.
Loosen the release / safety plate, making sure that the sharp accessories are
secure. (See Figure G)
Pole pruner (See Figure
I)
Install the bar of the main unit. Be sure that the locking pin is inserted in the hole of
the bar
Fix the bar by turning the nut anticlockwise.
Assembly of the chain guide and the cutting chain: (See Figure J、K)
Remove the safety screw and remove the guard.
Place the chain guide so that the safety pin on the chain engages in the chain's
teeth. Make sure that the direction of movement of the cutting chain is correct. Install
the chain guard and tighten the fastening screw. (See Figure L)
Adjusting the chain tension (See Figure M、N)
The chain must not have too much clearance, but it must be possible to lift the chain
a few millimeters from the guide rail.
Loosen the fixing screw.
Slightly lift the end of the chain guide
Check the cutting chain for ease of operation by turning it manually.
Adjust the tension of the chain by means of the screw for adjusting the tension
To Next Page
Loading...
