| English
29
Confirm that the fuel is not leaked from tank.
Transport the tool in a way to prevent loss of fuel, injuries and damage.
Dismantle the cutting head and the blade before transport and storage. Put the
blade in its packing.
f) Storage
Inspect, clean and have the appliance repaired if necessary
Empty the tank.
Switch on the appliance to consume all remaining fuel.
Remove the spark plug and pour a teaspoon of clean engine oil into the cylinder
cavity of the spark plug, replace the spark plug
Store cutting elements so that they cannot be touched (wrap them, for example.)
Store in a clean, dry, dust-free area.
ENGINE PROBLEM TROUBLESHOOTING CHART
Problem Check Status Cause Remedy
Engine cranks -
starts hard/
doesn't start
Fuel at
carburetor
No fuel at
carburetor
Fuel strainer
clogged Fuel
line clogged
Carburetor
Clean or replace Clean
or replace
See your dealer
Fuel at
cylinder
No fuel at
cylinder
Carburetor See your dealer
Muffler wet
with fuel
Fuel Mixture too
rich
Open choke
Clean/Replace air filter
Adjust carburetor.
See your dealer
Spark at
end of plug
wire
No spark
Stop switch off
Electrical
problem
Interlock switch
Turn switch to ON
See your dealer
See your dealer
Spark at
plug
No spark
Spark gap
incorrect
Adjust to 65mm (0.026
in.)
To Next Page
Loading...
