Total TP445441 - Operations: Engine Starting and Stopping; Engine Starting and Stopping Procedures; Cold and Warm Engine Starting

To Next Page

To Previous Page

OPERATIONS

ENGINE STARTING AND

STOPPING PROCEDURES

STARTING COLD ENGINE

Move the stop switch to “START”

position.

1. Give a gentle push on the primer pump

repeatedly (7-10times) until fuel comes

into the primer pump.

2. Cold Starts: Pull lever up to close choke.

3. Pull starter handle until engine flash. fires.

4. Push choke lever inwards (excessive cranking with choke lever will cause

flooding engine making it difficult to start).

5. Pull starter handle until engine starts.

6. Allow engine to warm up for a few minutes before using.

STARTING WARM ENGINE

z If fuel tank was not run dry, pull starter. one to three times and should

start.

DO NOT USE CHOKE

z If fuel tank was run dry, after refilling repeat steps 3 thru 7 in.

STARTING COLD ENGINE.

STOPPING THE ENGINE

z Move switch to STOP position

