Page 10.3
Viewing the Electric Heat Jumper SettingViewing the Electric Heat Jumper Setting
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
PROGRAM
Press
ON indicates that the
thermostat jumper is
set for Electric Heat
operation, or OFF for
Gas/Electric or Heat
Pump operation.
EH
I2
OFF
Setup
PROGRAM
MODE
MODE
Placing the jumper on ELEC will cause the thermostat to turn on the
fan immediately any time there is a heat demand. Since most gas
furnaces control the fan, this feature should be off unless the heater is
only electric.
Step 12 is ‘Read Only’ and may only be set with the jumpers on the
circuit board of the thermostat.
Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
TOTALINE
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the MODE
button to move back-
wards through the
setup screens.
10
To Next Page
Loading...
Need help?
General
