16 17
FILLING THE TANK
To ll the tank, push the button located on
the side of the tank and slide the top in the
direction indicated by the arrow. Once lled,
slide back closed. Please ensure to leave a
2mm air gap when lling, to avoid air-locking
the tank and preventing uid ow.
Note: After priming a new atomizer head and
lling the tank, it is recommended to wait 5
minutes to ensure the atomizer head is fully
saturated.
CHANGING THE ATOMIZER HEAD
To change the atomizer head, unscrew the
tank from the device by turning anti-clockwise
and invert, unscrew the base of the tank
by turning anti-clockwise. Pull out the old
atomizer head and dispose of. Follow the
steps found in “priming and installing the
atomizer head”. Screw the base of the tank
back on by turning clockwise. Finally attach
the tank on to the device by turning clockwise.
POWER ON AND OFF
To turn the device on or o, quickly press
the power button 5 times. The screen at the
top of the device will light up with the current
battery percentage when turning on, and will
go o completely when turning o.
VAPING
Press and hold the power button as you inhale
the vapour. The screen will indicate your
current vaping time whilst the power button is
held down to vape.
POWER MODES
The arc Mini 2 can be switched between
Wattage and Voltage mode, to change
between these modes quickly press the
power button 3 times to access the menu.
Once in the menu, use the adjustment
buttons to highlight either “V” (voltage) or “W”
(wattage), this is indicated by the V or the W
ashing. Conrm your selection by pressing
the power button once.
USING YOUR ARC MINI 2
TW-Arc-Mini-2-Manual-UK.indd 16-17TW-Arc-Mini-2-Manual-UK.indd 16-17 20/12/2023 13:2520/12/2023 13:25
To Next Page
Loading...
