55
Freeze Damage
Prevention
*2 Except SW4726AT40, SW4726, SW4724AT40, SW4724, SW4725.
When the ambient temperature is likely to drop to 32 °F
(0 °C) or lower, take measures to prevent freezing.
Attention
When the ambient temperature is likely to drop to 32 ° F
(0 °C) or lower, do not use the energy saver feature.
May damage the product.
Warm the bathroom or take measures against freezing
so that the ambient temperature does not drop below
32 °F (0 °C).
Before starting work, set "Auto ushing"
*1
(Page 33)
and "Auto open/close"
*2
(Page 37) to "OFF".
1. Close the shuto valve. (
Page 59)
X The water supply stops.
CAUTION
Do not remove the drain plug with water supply
lter while the shuto valve is open.
Otherwise, water may leak out.
2. Drain the water from the toilet tank.
Manipulate the lever/button/etc. until the water stops.
3.
Press "Wand CLEAN" button.
(Release the pressure from the water supply pipe.)
4. Turn the power "OFF". (
Page 47)
5. Drain the pipe.
1) Open the toilet seat and lid.
2) Insert a at-head
screwdriver in the
hook of the cover
to open it.
3)
Loosen the drain plug with water
supply lter with a at-head
screwdriver and then pull it.
Drain plug with
water supply lter
Cover
Flat-head screwdriver
Hook
Support the cover
with your hand
4) Only if the water supply hose is exposed on the
side of the main unit.
Drain the water from the water supply hose.
Water supply hose
Horizontally
6. Reinstall the drain plug with water supply lter and
close the cover.
1)
Insert the drain plug with water supply lter and
use a at-head screwdriver to tighten it securely.
Support the cover
with your hand
2)
Push it in until a click
is heard
7. Turn the power "ON". (
Page 47)
X The "Power" LED illuminates.
8.
Set the toilet seat temperature to "High".
(
Page 26)
X To maintain the temperature, close the toilet
seat and toilet lid after nishing work.
To use the product again
X The water needs to be resupplied. (
Page 57)
Reference
To Next Page
Loading...
