USING YOUR APPLIANCE
Functionality
Connect power lead to the cooking pot, and switch on at the wall.
Continually press the menu button on the control panel to select the required
cooking process. This will display the cooking time for this function, if you wish
to increase or decrease this time, you can do this by pressing the pre-set or
cancel button on the control panel to change the cooking time by a minute at a
time.
After 5 seconds the chosen cooking process will start.
If the function you are using has the adjust temperature feature (listed in the
programme guide on page 23) you can now adjust the temperature to what you
require by pressing the temperature button on the control panel.
Also if you require your food to be stirred during cooking, place the supplied
stirrer inside the cooking pot and lock into place by placing the stirrer onto the
metal rod in the base of the cooking pot and twist, to remove the stirrer twist and
remove. Once the cooking function has started press the stirring button straight
away to start this process, then press it again to stop this.
To stop cooking at anytime press the cancel button, this will place the cooker
into the stand-by mode.
To pre-set your cooking time only on the following functions, soup, risotto,
porridge and rice, before you have chosen your cooking function, press the
pre-set button to increase by 10mins or press your cancel button to decrease by
10mins, then choose your required cooking function, both the pre-set light and
the chosen function light will illuminate, once the pre-set time has expired your
chosen cooking function will proceed.
After your cooking process has finished the cooker will automatically go into the
keep warm function, apart from the steam & pasta functions, the cooker will stay
at between 65-70
o
C, if it goes over 70
o
C it will stop heating, if it falls below
65
o
C it will start to heat back up to 70
o
C.
To Next Page
Loading...
