Tower Hobbies T17038 - Getting Started and Preparation; Before First Use Procedures; Removing and Reinstalling the Door; Preparing the Appliance for Use

7
Before First Use:
Read all instructions and safety information carefully before first use. Please retain this
information for future reference.
1. Remove your appliance from the packaging.
2. Check that there is no damage to the cord or any visible damage to the body.
3. Dispose of the packaging in a responsible manner.
4. Remove any stickers or labels from the appliance
5. Thoroughly clean the fryer with hot water, some washing-up liquid and a non-abrasive sponge.
6. Wipe the inside and outside of the appliance with a moist cloth.
7. Do not fill the fryer with oil or frying fat. This is fryer operates using hot air and requires very
little to no oil.
Using Your Appliance.
Removing the door:
1. The air fryer has a removable door, which can be pulled apart from the appliance for easier
cleaning.
2. To separate the door from the air fryer, push the door as far down as it will go (about 70
degrees), then push the grooved latch on the right-hand side of the hinge horizontally to
release the door. Once the door has been released, pull it downward to separate it from the
body of the fryer.
3. To reinstall the door, align the edges of the door with the holes on either side of the hinge, and
insert it as shown in the images below.
Automatic Switch Off:
The Tower Air Fryer has a built in timer, which will automatically shut off the air fryer when the timer
reaches zero.
You can manually switch off the air fryer by turning the temperature control dial counter-clockwise
until it reaches zero. You will hear a ringing sound to indicate the timer is at zero.
Preparing For Use:
1. Place the appliance on a stable, horizontal and even surface. Do not place the appliance onto a
non-heat-resistant surface.
2. Pull the cord from the storage compartment located at the bottom of the appliance.
3. Do not fill the fryer with oil or any other liquid.
4. Do not put anything on top of the appliance, as this will disrupt the airflow and the hot air
frying will be affected as a result.
Air Frying:
1. Connect the mains plug into an earthed wall socket.
2. Open the air fryer door.
3. Put the ingredients into the air fryer.