6
Before First Use:
Read all instructions and safety information carefully before first use. Please retain this information
for future reference.
1. Remove the product from the box.
2. Remove any packaging from the product. Check for any visible signs of damage to the
appliance or adaptor.
3. Please retain all packaging until you have checked and counted all the parts and the contents
against the parts list.
4. Dispose of the packaging in a responsible manner.
Wall-Mounting the Appliance:
This unit can be wall-mounted when not in use.
CAUTION! When drilling holes in the wall, take extreme care not to damage any concealed cables
or pipes on the wall, as this could cause a hazard. If in doubt, seek out a qualified handyman to carry
out the procedure.
1. To wall-mount the appliance, begin by affixing the included wall mount to the wall. To do this,
begin by choosing an adequate position and height, roughly one metre above the ground, and
mark it on the wall with a pencil, as shown in Figure 1.
2. Hold the wall bracket level to the marking and mark the position of the two screw holes
through the bracket, as shown in Figure 2.
3. Remove the wall bracket from the wall and drill two holes over the pencil markings with a
6mm masonry drill (not included).
4. Once the two holes have been appropriately drilled, insert one of the included wall plugs into
each hole. Ensure each wall plug is firmly secured into place before proceeding.
To Next Page
Loading...
