Toyan
●Model engines generate considerable heat. Do not touch any part of your engine until it has cooled. Contact with the
muffler,cylinder head or exhaust header pipe, in particular, may result in a serious burn.
NOTES:
●
This engine was designed for science experiments, model demonstrations, model car drives. Do not attempt to use
it for any other purpose.
●
Mount the engine in your model securely, following the manufacturers' recommendations, using appropriate screws
and locknuts.
●
Noise will happen when starts, please buy our matching muffler exhaust pipe or run away from the living
environment, because the noise of the operation may irritate others
●
Safety glasses are strongly recommended
● Please note that the electric plug or battery wire should not touch the rotating parts. Also check whether the
connection of the throttle rocker arm is firm
● To be safe, keep all spectators (especially children) at least 3 meters away from engine when start the engine
●
If you want to stop engin, shut off the throttle completely. In an emergency, clamp the fuel line in
front of the carburetor
to cut off the fuel supply
●
Do not attempt to remove the flywheel and start the synchronous pulley
●
Do not extend the starting battery wire by more than 20cm. Otherwise, the starting current will be
insufficient due to
the resistance voltage drop inside the battery line
● When starting the engine, please do not press the start button for a long time. The maximum starting time is 5 seconds.
If it does not start, please stop for 15 seconds and press the button to start again, so as not to burn the starting motor
and ignition circuit due to the long starting.
To Next Page
Loading...
Need help?
General
