TOYOTA CAMRY LE / SE / XLE 2012- SEAT HEATER KIT
Section III – Functional Verifications
Page 7 of 8
Form #5386, Rev. B, 07-11-2014
Check Look For
Verify Function and Heat: IGN ON, Check switch
in both ‘High’ and ‘Low’ position.
Switch in ‘High’ setting. The LED will turn red.
The heat will be noticeable within 3 minutes. The
heating time can vary according to the type of seat
cover material and kind of clothing/coat that is being
worn. The heating must be switch to the ‘Low’
setting in order to avoid overheating, when the
desired temperature has been reached.
Switch in ‘Low’ setting. The LED will turn green.
The heating time can vary according to the type of
seat cover material and kind of clothing/coat that is
being worn.
Troubleshooting
The heating does not function although it is switched
on. The LED is not illuminated.
Check the fuse and change if necessary.
The LED in not illuminated although the heating is
functioning and switched on.
The LED in the switch is defective.
The heating does not function although it is switched
on. The LED is on.
The temperature of the seat cover could be too high
due to high interior temperature. The thermostat in
the seat heating unit is connected. Wait until the seat
cover’s temperature has fallen and try again.
The fuse burns out repeatedly. Verify the fuse rating is correct: 10 amps.
To Next Page
Loading...
