Toyota PT278-42130 - User Manual

TOYOTA RAV4/HV 2013 - CROSSBAR KIT
Preparation
Page 1 of 6 pages
Issue: G 12/13/2016
Part Number: PT278-42130
Kit Contents
Item # Quantity Reqd. Description
1 1 Crossbar Assembly Front (long)
2 1 Crossbar Assembly Rear (short)
3 1 Hardware Bag
Hardware Bag Contents
Item # Quantity Reqd. Description
1 1 Key
2 2 Forward Limit Label
3 1 Installation Instructions
Additional Items Required For Installation
Item # Quantity Reqd. Description
1
2
3
Conflicts
Recommended Tools
Personal & Vehicle
Protection
Notes
Safety Glasses
Safety Gloves
Vehicle Protection Cloth
Wrist & Belt Buckle
Protection
Special Tools Notes
Installation Tools Notes
Tape Measure (Metric)
Non-Intrusive Infrared Temp
Probe/Gun
Heat Gun
Special Chemicals Notes
Cleaner Approved Cleaner
General Applicability
Recommended Sequence of Application
Item # Accessory
1
2
3
*Mandatory
Vehicle Service Parts (may be required for reassembly)
Item # Quantity Reqd. Description
1
2
3
Legend
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY: Use caution to avoid risk of
injury.
CAUTION: A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT: Used in Figures calls out the
specific tools and equipment recommended for this
process.
REVISION MARK: This mark highlights a change in
installation with respect to previous issue.
SAFETY TORQUE: This mark indicates that torque is
related to safety.

Summary

Prepare and Install Front Crossbar

Loosen Levers Without Disengaging

Install Front Crossbar

Install the front crossbar at an angle parallel to the roof surface, sliding supports over side rails.

Position Front Crossbar

Straighten crossbar so support front is 100mm rearward of the warning label.

Verify Front Crossbar Orientation

Secure Front Crossbar

Tighten Lever Clockwise

Turn the lever clockwise to tighten the clamp to the crossbar securely.

Adjust and Close Lever

Lock Crossbar Position

Use the supplied key to turn the lock in the lever, securing the crossbar.

Prepare and Install Rear Crossbar

Install Rear Crossbar

Install the rear crossbar at an angle parallel to the roof surface, sliding supports over side rails.

Position Rear Crossbar

Verify Rear Crossbar Orientation

Secure Rear Crossbars

Tighten Rear Lever Clockwise

Adjust and Close Rear Lever

Lock Rear Crossbar Position

Toyota PT278-42130 Specifications

General

Material	Aluminum
Color	Black
Compatibility	Toyota vehicles
Finish	Textured
Part Number	PT278-42130
Category	Automobile Accessories
Manufacturer	Toyota