TOYOTA 4RUNNER 2006 - HOOD PROTECTOR
Preparation
Page 1 of 5 pages
Su
lier Ref. #I-1136
Issue: A 8/14/06
Part Number: PT427-89060
PT427-8906B
NOTE: Part number of this accessory may not be
the same as the part number shown.
Kit Contents
Item # Quantity Reqd. Description
1 1 Hood protector
2 1 Hardware bag
Hardware Bag Contents
Item # Quantity Reqd. Description
1 4 Outside hood bracket
2 2 Grill hood bracket
3 2 Grill Hook bracket
4 4 6-32 well nut
5 4 6-32 x 0.5 MS
6 4 #6 SS flat washer
7 6 10-24 MS
8 4 Mylar pad - small
9 2 Double-sided tape
10 2 Mylar pad – large
Additional Items Required For Installation
Item # Quantity Reqd. Description
Conflicts
Recommended Tools
Personal & Vehicle
Protection
Notes
Vehicle Protection Blanket
Special Tools Notes
None
Installation Tools Notes
Screwdriver Phillips, #2
Ratchet Phillips #2 Bit
Special Chemicals Notes
Cleaner Soap and Water
General Applicability
Note-
Recommended Sequence of Application
Item # Accessory
1
2
3
*Mandatory
Vehicle Service Parts (may be required for reassembly)
Item # Quantity Reqd. Description
1
2
3
Legend
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY:
Use caution to avoid risk of
injury.
CAUTION:
A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT:
Used in Figures calls out the
specific tools and equipment recommended for this
process.
To Next Page
Need help?
General
