TOYOTA CAMRY LE / SE / XLE 2012- DUAL SEAT HEATER KIT
Section II –Installation
Page 6 of 8
Form #5386, Rev. B, 07-11-2014
Install Switches
1. Use the Camry drill fixture to make 3/8” pilot
holes in trim piece. Enlarge hole with a
13/16” (21mm) hole saw. Figures 14a-15
NOTE: Camry LE / SE share one fixture, Camry
XLE is a separate fixture.
2. Push the switch harness through hole and snap
the switch firmly into place. Figure 16
3. Connect the switches to the switch inputs on
the main harnesses in the center console.
Connect left (driver) switch to the 4-pin
connector marked with the red tape, and
connect the right (passenger) switch to the 4-
pin connector marked with the blue tape.
4. Use the Seat Heater Harness Tester to validate
switch and harness function and orientation.
5. Reinstall all trim panels in the reverse order of
removal.
6. Reconnect battery cable(s). Torque 10mm bolt
to 48 inch-pounds. Re-enter any theft
deterrent information, if applicable.
Figure 16
Figure 15
Drill (2) 13/16”
Holes
Figure 14a
Figure 14b
Camry LE / SE
Camry XLE
To Next Page
Loading...
