32
TOYOTA SAFETY SENSE
™
CHANGING PCS WARNING TIMING
Far
Middle
(default)
Near
(1) Press “ ” switches and select “ ” from the Multi-Information Display (MID).
(2) Press “
” switches and select “ PCS” and then press “ .” The setting
screen is displayed.
(3) Press “
” switches and select “Sensitivity” and then press “ ” to change
the warning timing. Each time it is pressed, the PCS warning timing changes as
shown above.
(4) Press “
” to go back to the menu.
Note: PCS is enabled each time the vehicle is turned on. The system can be
disabled/enabled and the alert timing of the system can be changed. (Alert
timing only, brake operation remains the same.)
Monocular camera sensor
Millimeter
wave radar
As part of the Pre-Collision System, this function is also designed to first provide an
alert and then automatic braking if needed.
Refer to the Toyota “Owner’s Manual” for additional limitations and information.
Under certain conditions, the PCS included with the TSS-P package may also help
to detect a pedestrian in front of your vehicle using the forward-facing camera and
front grille-mounted radar. The forward-facing camera of PCS detects a potential
pedestrian based on size, profile, and motion of the detected pedestrian. However,
a pedestrian may not be detected depending on the conditions, including the
surrounding brightness and the motion, posture, size, and angle of the potential
detected pedestrian, preventing the system from operating or engaging.
PCS PEDESTRIAN DETECTION
To Next Page
Loading...
