40
TOYOTA SAFETY SENSE
™
Monocular camera sensor
Millimeter
wave radar
As part of the Pre-Collision System, this function is also designed to first provide an
alert and then automatic braking if needed.
Refer to the Toyota “Owner’s Manual” for additional limitations and information.
Under certain conditions, the PCS included with TSS 3.0 may also help to detect a
pedestrian, bicyclist or motorcyclist in front of your vehicle using the forward-facing
camera and the front radar sensor. The forward-facing camera of PCS detects a
potential pedestrian, bicyclist or motorcyclist based on size, profile, and motion of
the detected pedestrian, bicyclist or motorcyclist. However, a pedestrian, bicyclist
or motorcyclist may not be detected depending on the conditions, including the
surrounding brightness and the motion, posture, size, and angle of the potential
detected pedestrian, bicyclist or motorcyclist, preventing the system from operating
or engaging.
PCS PEDESTRIAN DETECTION
CHANGING PCS WARNING TIMING
(1) Press “ ” or “ ” switches and select “ (4.2-in display)” or “ (7-in
display)” from the Multi-Information Display (MID).
(2) Press “
” or “ ” switches and select “ PCS” and then press and hold
“
.” The setting screen is displayed.
(3) Press “
” or “ ” switches and select “Warning timing” and then press “ ”
to change the desired setting. Each time it is pressed, the PCS warning timing
changes “Later” or “Default” or “Earlier.”
(4) Press “
” to go back to the menu.
Note: PCS is enabled each time the vehicle is turned on. The system can be
disabled/enabled and the alert timing of the system can be changed. (Alert
timing only, brake operation remains the same.)
To Next Page
Loading...
