52
TOYOTA SAFETY SENSE
™
TEMPORARILY SWITCHING TO THE LOW BEAMS
Pull the lever rearward and then return it to its original position to switch to the low
beams temporarily.
The high beams will illuminate while the lever is pulled. However, after the lever is
returned to its original position, the low beams will remain on for a certain period of
time. Afterwards, the Automatic High Beams will be activated again.
NOTE: It is recommended to switch to the low beams when use of the high
beams is inappropriate or the high beams may cause problems or distress to
other drivers or pedestrians nearby.
Road Sign Assist (RSA)
Using the forward-facing camera and navigation system (if equipped), Road Sign
Assist (RSA) is designed to detect certain road signs and display them on the
instrument cluster.
All vehicle actions must be driver-initiated and are not automated.
Refer to the Toyota “Owner’s Manual” for additional information and limitations.
SUPPORTED TYPES OF ROAD SIGNS
Speed limit
Stop
Do Not Enter
Yield
No U-turn
Warning
No Turn On Red
The following types of road signs can be displayed.
To Next Page
Loading...
